User Manual Unique UGP-290L1-DC-B Off-Grid Solar DC Top-Freezer Refrigerator

Documents for Unique UGP-290L1-DC-B

The following documents are available:
User Manual Other Documents Photos
UGP-290L1-DC-B photo
7
INSTALLATION
UNPACKING AND CLEANING
Remove all packaging and securing tapes from the appliance.
+ƫ2+% ƫ%*&1.5ƫ* ƫ1/%*#ƫ )#!ƫ0+ƫ0$!ƫ,,(%*!Čƫ!ƫ!40.!)!(5ƫ
cautious when using sharp or pointed tools to complete this task.
Keep children away from the packaging material - DANGER OF SUF-
FOCATION! Wash the inside and outside of the appliance with luke
warm water and a mild soap or detergent. Abrasive or corrosive
cleaning agents, steel wool, scouring sponges, or chemical cleaning
agents should not be used under any circumstances. A sponge, soft
brush or towel is recommended. After cleaning, thoroughly rinse and
dry. You may want to leave the doors open allowing the compart-
ments to ventilate for 20-30 minutes to get rid of residual odors.
Check with your local Environmental Agency for recommendations
on recycling packaging materials in your area.
POSITIONING THE APPLIANCE
The area in which the fridge is to be installed must be relatively cool,
dry, and suitably ventilated. The area must be protected against any
%*(!)!*0ƫ3!0$!.ƫĨ.%*Čƫ/*+3ĩƫ* ƫ!4!//%2!ƫ/1."!ƫ 1/0ċƫƫ+ƫ!*/1.!ƫ
,.+,!.ƫ"1*0%+*Čƫ0$!ƫ,,(%*!ƫ)1/0ƫ!ƫ,(! ƫ$+.%6+*0((5ƫ+*ƫƫý0Čƫ
ü.)Čƫ* ƫ/0(!ƫ/1."!ƫ.!/0%*#ƫ(!2!(ƫ+*ƫ((ƫ"+1.ƫ/1,,+.0/ċƫ$!ƫý++.ƫ
must be strong enough to support a fully loaded cabinet. Use wood
or metal shims to level the fridge if necessary.
+ƫ*+0ƫ,(!ƫ0$!ƫ".% #!ƫ(+/!ƫ0+ƫ$!0ƫ/+1.!/ƫĨ$!0!.Čƫ/0+2!Čƫ+%(!.Čƫ
$%)*!5Čƫ!0ċĩČƫ* ƫ2+% ƫ,.+(+*#! ƫ!4,+/1.!ƫ0+ƫ %.!0ƫ/1*(%#$0ċƫƫ$%/ƫ
,,(%*!ƫ1/!/ƫ0$!ƫ!40!.%+.ƫ3((/ƫ0+ƫ0.*/"!.ƫ$!0ƫ".+)ƫ0$!ƫ%*/% !ƫ+"ƫ
the cabinet. Ensure that there is adequate space between the fridge
* ƫ*!%#$+.%*#ƫ3((/ƫ+.ƫ(.#!ƫ+&!0/ċƫƫƫ)%*%)1)ƫ/,%*#ƫ+"ƫăƫ
%*$!/ƫĨĈċĆƫ)ĩƫ%/ƫ$%#$(5ƫ.!+))!* ! ċƫƫ$%/ƫ3%((ƫ,.+2% !ƫ/1þ%!*0ƫ
%.ý+3ƫ.+1* ƫ0$!ƫ,,(%*!ƫ.!/1(0%*#ƫ%*ƫ)+.!ƫ!þ%!*0ƫ+,!.0%+*ƫ* ƫ
longer appliance lifetime. Always keep the air vent openings of the
compressor housing cover free from dust and obstructions.
DOOR REMOVAL AND REVERSAL INSTRUCTIONS
NOTE: $!ƫ %.!0%+*ƫ%*ƫ3$%$ƫ5+1.ƫ.!".%#!.0+.ƫ ++./ƫ+,!*ƫĨ ++.ƫ
/3%*#ĩƫ*ƫ!ƫ.!2!./! Čƫ".+)ƫ(!"0ƫ0+ƫ.%#$0ƫ+.ƫ.%#$0ƫ0+ƫ(!"0Čƫ5ƫ)+2%*#ƫ
the door hinges from one side to the other. Reversing the door swing,
should be performed, by a qualified person.
1. Remove top hinge cover
2. Remove top hinge with Philips screwdriver and lift freezer door o
of center hinge and set door aside.
3. Unscrew center hinge with Phillips screwdriver
Loading ...
Loading ...
Loading ...