Loading ...
Loading ...
Loading ...
19ENGLISH
NOTE:
Theentirelterassemblyshouldbe
cleaned once a week.
Cleaning The Filter
Tocleanthecoarselterandthene
lter,useacleaningbrush.Reassemble
thelterpartsasshowninthegures
on the last page and reinsert the entire
assembly in the dishwasher, positioning
in its seat and pressing downward.
WARNING!
Whencleaningthelters,don't
knock on them. Otherwise, the
lterscouldbecontortedandthe
performance of dishwasher could be
decreased.
7.2 Caring for the Dishwasher
The control panel can be cleaned by
using a lightly dampened cloth. After
cleaning,make sure to dry it thoroughly.
For the exterior use a good appliance
polish wax.
Never use sharp objects, scouring pads
or harsh cleaners on any part of the
dishwasher.
Cleaning The Door
To clean the edge around the door, you
should use only a soft warm, damp cloth.
To avoid penetration of water into the
door lock and electrical components, do
not use a spray cleaner of any kind.
WARNING!
• Never use a spray cleaner to clean
the door panel as it may damage
the door lock and electrical
components.
• Abrasive agents or some paper
towel should not be used because
of the risk of scratching or leaving
spots on the stainless steel
surface.
Protect Against Freezing
please take frost protection measures on
the dishwasher in winter.
As follows:
1. Turn off electrical power to the
dishwasher.
2. Turn off the water supply and
disconnect the water inlet pipe from
the water valve.
3. Drain water from the inlet pipe and
water valve (Use a pan to catch the
water)
4. Reconnect the water inlet pipe to the
water valve.
5. Removethelteratthebottomof
the tub and use a sponge to soak up
water in the sump.
NOTE:
If your dishwasher cannot work
because of the ice, please contact
authorised service person.
Cleaning the Spray Arms
The spray arms can be easily removed
for periodic cleaning of the nozzles to
prevent possible clogging. Wash them
under running water and carefully replace
them in their seats, checking that their
rotary movement is in no way impeded.
Grasp the middle of the spray arm, pull
it upwards to remove it. Wash the arms
under a jet of running water and replace
it carefully to its seat. After reassembly,
check that the spray arms rotate freely.
Otherwise, check that they have been
installed correctly.
Loading ...
Loading ...
Loading ...