Loading ...
Loading ...
Loading ...
30
RESOLUCIÓN DE PROBLEMAS
PROBLEMA POSIBLES CAUSAS
CÓMO CORREGIR
EL PROBLEMA
La bomba no
funciona
La bomba zumba
pero no funciona
Cable suelto, corroído o conexiones
invertidas
Apriete, limpie o vuelva a conectar,
según se requiera
Batería descargada Cargue la batería
Batería defectuosa Reemplace la batería
Fusible fundido Reemplace con un fusible de 20 A
Interruptor de flotador atorado
Coloque el flotador de manera que se
mueva libremente
Batería descargada a menos de 10 voltios Cargue por completo la batería
La bomba se
encienda y apaga
con demasiada
frecuencia
Interruptor de flotador en posición incorrecta
Cambie la posición del interruptor de
flotador
Válvula de paso defectuosa o ausente Instale o reemplace la válvula de paso
La bomba funciona,
pero no mueve agua
o mueve muy poca
Batería descargada o con carga baja Cargue por completo la batería
Obstrucción en el tubo Elimine la obstrucción
La altura o longitud del tubo de descarga
exceden la capacidad de la bomba
Consulte la sección sobre desempeño
para conocer la capacidad de esta bomba
Válvula de paso defectuosa
Reemplace la válvula de paso si es
necesario
7
TESTING YOUR INSTALLATION
1. Once your installation and wiring connections are complete, unplug or disconnect the
power to the primary pump.
2. Fill the basin using buckets or a hose. Observe the float switches to make sure they are
positioned properly when the basin is filling. Fill the basin until the backup float activates
the alarm. The pump should start and drain the basin to level of the
3. Make any necessary adjustments to the float(s) and/or pumps at this time.
OPERATION
1. When the power fails or when there is a problem with the primary pump, the back-up
pump will automatically start. The back up pump will operate for many hours
intermittently. During prolonged periods of power outage the pump may stop pumping
when the battery voltage drops below 10 volts. When this happens the alarm will sound
signaling that the voltage is too low to operate the pump.
2. This unit is equipped with a 2 amp charger. It will charge a discharged battery at a rate of
2 Ah (Amp hours). Once the battery reaches a full charge, the charger will gradually
reduce the charge rate. It will also maintain a charged battery by periodically checking the
voltage of the battery.
3. The charger is equipped with over charge protection. I will not let the battery become over
charged.
Loading ...
Loading ...
Loading ...