Loading ...
Loading ...
Loading ...
6
WIRING & ELECTRICAL CONNECTIONS
1. If necessary, attach the provided battery terminals to the battery. (Many deep cycle ma-
rine batteries come with a threaded post terminal built in.) NOTE: The provided battery
terminals are labeled (+) positive and (-) negative. Make sure the terminals are connected
to the proper terminal on the battery. Place the battery in the battery box.
2. Connect the battery lead wires from the control panel to the corresponding terminals on
the battery. Connect the red (+) positive lead to the positive battery terminal and tighten
the wing nut. Connect the black (-) negative lead to the negative battery terminal and
tighten the wing nut. Once the battery is connected, the alarm will beep 4 times to confirm
the battery has been connected properly. Secure the battery box cover to the lower case.
3. Next connect the pump power cord, the float switch and the AC adapter to the corre-
sponding terminals on the control panel. Make sure they are fully seated in the terminals.
4. Plug the AC adapter into the wall outlet and turn the power back on
5. If your battery is fully charged you will notice a green light on the AC adapter. If the bat-
tery is not fully charged a red light will indicate that the battery is charging. Once fully
charged, the light will change to green.
6. Test the float switch and pump by lifting and holding the float. The alarm will sound and
the “PUMP ON” light on the control panel will illuminate. The pump should start after lift-
ing the float. If it does not run, check your connections and retry.
7. Test the “MUTE” button when the alarm is sounding. Press once to mute the alarm. The
MUTE ON light should illuminate. Press again to re-activate the alarm.
31
AVISO
La restricción de altura o tubería reducirá el rendimiento de salida de la bomba.
Consulte la tabla de rendimiento que aparece abajo para asegurar que tenga la bomba
apropiada para la aplicación. Cuando sea posible, use tubería del mismo tamaño o mayor que
la descarga de la bomba para obtener el rendimiento óptimo. La reducción del tamaño del tubo
no causará daños a la bomba, solo reducirá la salida.
RENDIMIENTO
* Las clasificaciones de rendimiento se basan en una batería marítima de ciclo profundo
27M de 12 voltios, con clasificación de 100 Ah.
ESPECIFICACIONES
Motor 12 voltios CC
Amperios 13
Requisitos de la batería Marítima de 12 voltios
Corte por bajo voltaje 10 voltios
Manejo de sólidos 3 mm (1/8")
Tamaño de descarga 32 mm (1 1/4") o 38 mm (1 1/2")
Cargador de baterías 2 amperios
Intervalo de temperaturas del líquido 0 °C a 49 °C (32 °F a 120 °F)
Garantía 1 año
Núm.
modelo
Salida en galones por minuto con la altura de descarga
Indicada sobre el nivel de bombeo
0m (0’) 1,5m (5’) 3m (10’) 4,6m (15’) 6,1m (20’)
92900, 92910 23 22 18 13 8
Loading ...
Loading ...
Loading ...