Loading ...
Loading ...
Loading ...
49
WATER CONNECTION - WATER DRAINAGE
WATER CONNECTION :
The inlet and drain hoses can be directed to left or right.
The dishwasher can be connected to either cold or hot water, as long as it is no hotter than
60°C.
Water pressure mut be between 0,08 MPa and 0,8 MPa. If the pressure is below the
minimum consult the service department for advice.
The inlet hose must be connected to a tap so that the water supply can be cut off when the
machine is not in use (fig.1). The dishwasher inlet hose is fitted with a 3/4" threaded connector
(fig.2). The inlet hose "A" should be tightly connected to a 3/4" tap "B".
The water connection of the dishwasher must be done exclusively with the pipe supplied. Do
not use an old pipe.
If lime scale deposits or sand are present in the water, it is advisable to obtain the appropriate
filter, art. 9226085, from the Service Centre (fig.3). The filter "D" must be inserted between the
tap "B" and the inlet hose "A", remembering to fit the washer "C".
If the machine is connected to new pipes or to pipes which have not been in use for long
time, run water through for a few minutes before connecting the inlet hose. In this way no
deposits of sand or rust will clog up the water inflow filter.
WATER DRAINAGE :
Take care not to bend or kink the drain hose when connecting it to the machine so that the
water can drain freely from it (fig.4y).
The drain hose must be at least 40 cm above floor level and it must have an internal diameter
af at least 4 cm. It is advisable to fit an anti-odour air trap (fig.4x).
If necessary, the outlet hose can be extended up to 2,6 m, provided that it is kept at a
maximum height of 85 cm above floor level. For this, contact Customer Service.
Downloaded from www.ManualsFile.com manuals search engine
Loading ...
Loading ...
Loading ...