Loading ...
Loading ...
Loading ...
42
If you wish to change or cancel a programme that is running, carry out the following procedure:
. open the door, keeping the Programme selection button "P" pressed in until all 4 indicator
lights are flashing. The current programme is cancelled. A new setting can now be made.
Before starting a new programme, you should check that there is still detergent in the
dispenser. If necessary, top up the dispenser.
WARNING: if the door is opened during the drying phase, an intermittent audible signal is
activated to advise that the cycle is not yet completed.
End of programme
The end of the programme is indicated by an audible signal. When the door is opened the
programme selection indicator lights start flashing. Release the On/off button.
Deactivating the audible signal
The audible function can be deactivated in the following way:
- press the On / Off button
- wait till the programme LEDs blink
- within 2 minutes, press and keep pressed for at least 30 seconds the Programme Selection
button (the programme LEDs will still blink and an intermittent audible signal is heard).
- Once the first two LEDs on the left are illuminated without blinking and the audible signal is
off, release the button (the audible signal function is active).
- Press again the Programme Selection button, the first two LEDs on the left will go off and
the other two LEDs will turn on (the audible signal function is deactivated)
- An audible signal will confirm that the setting is completed
- To set again the audible signal function repeat the whole procedure.
Attention - The dishwasher is equipped with an anti-overflow safety device which in the
event of anomaly intervenes by evacuating water in excess.
Fault Signals
If malfunctions or faults occur when a program is running, the LED that corresponds to the
selected cycle (2 LEDS for COLD RINSE programme) will blink rapidly and an audible signal
will be activated.
In this case, turn the dishwasher off by pressing the On / Off button. After checking to make
sure the water inlet hose tap is open, that the drain hose is not bent and that the siphon or
filters are not clogged, re-start the selected program. If the anomaly persists, contact
Customer Service.
Important !
To ensure the correct operation of the anti-overflow safety device, it is recommended
not to move or to tilt the dishwasher during operation.
If it is necessary to move or to tilt the dishwaher, first make sure the washing cyle is
finished and that no water is left in the tank.
Downloaded from www.ManualsFile.com manuals search engine
Loading ...
Loading ...
Loading ...