Loading ...
Loading ...
Loading ...
15
4. Hook the seal in to the bottom of the panel again (fig. D).
5. Insert the uppermost panel at an angle to the back into the
brackets. Take care not to push the seal to the back (fig. E).
6. Insert the two small seals on the left and right of the panel
again (fig. F).
7. Put the cover back in place and screw it on.
8. Attach the oven door.
Do not use the oven again until the panels have been
correctly installed.
Troubleshooting
Quite often, when there is a malfunction, it is usually a small
irregularity which is easy to rectify. Before contacting the
Technical Assistance Service, try to determine the cause of the
fault using the following table.
Troubleshooting table
Error messages
When the display panel shows an error message with
“, press
the
0 button. The message will disappear. The set time
function will be deleted. If the error message does not
disappear, call the Technical Assistance Service.
The following error messages can be solved by the user.
: Risk of electric shock.!
Incorrect repairs can be dangerous. Repairs may only be
carried out by qualified personnel from the Technical Support
Service.
'
&
)
(
Fault Possible cause Solution/advice
The oven does
not work.
The fuse has
blown.
Check the condition of the
fuse in the fuse box.
Power cut. Check that the light in the
kitchen and other house-
hold appliances are work-
ing.
0 lights up on
the display with
some zeros.
Power cut. Set the time once again.
The oven does
not heat up.
There is dust on
the contacts.
Turn the control knobs sev-
eral times in both direc-
tions.
The oven door
does not open.
The L symbol
lights up on the
display panel.
The oven door
has been locked
by the self-
cleaning
function
q.
Wait until the oven has
cooled and the
L symbol
turns off.
The oven does
not heat up.
The two points
on the display
panel flash.
The oven is in
demo mode.
Disconnect the fuse from
the fuse box and reconnect
after around 20 seconds.
Then, within around
2 minutes, press the D
button for approx.
4 seconds until the two
points stay lit.
The display
shows
”‰.
The appliance
has been auto-
matically turned
off.
Turn the function control
knob to the zero setting.
Error message Possible cause Solution/advice
“‹‚‚
A button has
been pressed
for too long or
has got stuck.
Press all of the buttons one
by one. Check if any button
is stuck, covered or dirty.
“‚‹‡
The door lock
has been acti-
vated with the
door open.
Press the
0 button. You
can now begin program-
ming again.
“‚‚†
The tempera-
ture inside the
oven is too
high.
The oven door is locked
and heating has stopped.
Wait until the oven has
cooled. Press the
0 but-
ton and reset the time.
Loading ...
Loading ...
Loading ...