Loading ...
Loading ...
Loading ...
12
Delaying the end time
The oven can be set to end the self-cleaning at a specific time.
Self-cleaning can therefore be programmed at night for
example, leaving the oven free for use during the day.
Programme as described in point 1 and 2. Before cleaning
starts, put back the time with the
@ or A buttons.
The oven is set to standby. The time when the cleaning will be
finished is displayed and the
p symbol will be shown in square
brackets. When the cleaning starts, the cooking time is
displayed and the
r symbol appears in square brackets.
The
p symbol switches off.
After using the self-clean function
Once the inside of the oven has cooled, clean the ash remains
using a damp cloth.
Care and cleaning
If cleaned and properly cared for, your oven will keep its bright
appearance and operating performance for many years to
come. Advice on how to care for and clean your oven is
provided below.
Notes
■ Different colours may be seen in your front panel due to the
various materials used in its manufacture, such as glass,
plastic and metal.
■ Dark patches in the door's glass panel may seem to be dirt
but they are in fact reflections from the oven light.
■ Enamel burns at very high temperatures. This may cause
slight discolouration. This is normal and does not affect the
oven's operation. The edges of thin baking trays may not be
completely enamelled. They may therefore feel slightly rough,
although their corrosive protection will be unaffected.
Cleaning products
Follow the indications provided in the table to avoid damaging
the various oven surfaces by using unsuitable cleaning
products. Do not use
■ abrasive or acidic cleaning products
■ strong products containing alcohol
■ scourers or hard sponges
■ high-pressure or steam cleaners.
Wash new dishcloths thoroughly before use.
Light
The oven light can be turned on manually to facilitate cleaning.
Turning on the oven light
Turn the function control knob to the
^ position.
The light will come on. The temperature control knob must be
turned off.
Turning the oven light off
Turn the function control knob to the
Ûposition.
Zone Cleaning products
Front panel Hot water and a little soap:
Clean with a dishcloth and dry with a
soft cloth. Do not use a glass clean-
ing product or a glass scraper.
Stainless steel Hot water and a little soap:
Clean with a dishcloth and dry with a
soft cloth. Immediately remove any
water marks, grease, cornflower or
egg white stains since corrosion
could occur underneath these marks
or stains.
Special products for the care of
stainless steel which are suitable for
hot surfaces may be obtained from
Technical Assistance Service cen-
tres and specialist retail outlets. Use
a very fine soft cloth to apply the
cleaning product.
Glass panel Glass cleaning products:
Clean with a soft cloth. Do not use a
glass scraper.
Display Glass cleaning products:
Clean with a soft cloth. Do not use
alcohol, vinegar or other abrasive or
acidic cleaning products.
Glass panels on oven
door
Glass cleaning products:
Clean with a soft cloth. Do not use a
glass scraper.
Door covering Only use products specially for
cleaning stainless steel (these can
be obtained from the Technical
Assistance Service or from specialist
shops). Follow the manufacturer's
instructions.
Inside the oven Hot water with a little soap or water
and vinegar:
Clean with a dishcloth.
If very dirty, use a stainless steel
scourer or special oven cleaning
products. These must only be used
when the oven interior is cold.
Whenever possible, use the self-
cleaning function. See the chapter
on the Self-cleaning function.
Glass cover for the oven
light
Hot water and a little soap:
Clean with a dishcloth.
Guides or rails Hot water and a little soap:
Soak and clean using a dishcloth or
brush.
Sliding guides Hot water and a little soap:
Clean with a dishcloth or a brush.
Do not leave this to soak or wash in
a dishwasher.
Accessories Hot water and a little soap:
Soak and clean using a dishcloth or
brush.
Zone Cleaning products
Loading ...
Loading ...
Loading ...