Loading ...
Loading ...
Loading ...
9
How to Connect the MEN220
How to Connect the MEN220
The MEN220 has the ability to be remotely switched
On/Off from a Preamplifier or A/V Control Center via
the Power Control connection. The Data Port Connec-
tion allows for the remote operation of basic functions
using the MEN220 Remote Control. With an external
sensor connected to the MEN220, remote control op-
eration is possible from another room and/or when the
MEN220 is located in a cabinet with the doors closed.
The connection instructions below, together with
the MEN220 Connection Diagram “Mc1A” located
on the separate folded sheet, is an example of a typi-
cal audio system. Your system may vary from this,
however the actual components would be connected in
a similar manner. For additional information refer to
“Connector and Cable Information” on page 4.
Power Control Connections:
1. Connect a Control Cable from the Preamplifier or
A/V Control Center Power Control MAIN Jack to
the POWER CONTROL IN Jack on the McIntosh
MEN220.
2. Connect a Control Cable from the MEN220 POW-
ER CONTROL OUT Jack to the Power Amplifier
1 Power Control In Jack.
3. Connect a Control Cable from the Power Ampli-
fier 1 Power Control Out Jack to the Power Ampli-
fier 2 Power Control In Jack.
4. Connect any additional components in a similar
manner, as outlined in steps 2 thru 3.
Data Control Connections:
5. Connect a Control Cable from the Preamplifier or
A/V Control Center SUM Data Port Jack to the
McIntosh MEN220 DATA IN Jack.
Note: If the Preamplifier or A/V Control Center
doesn’t have a SUM Data Port Jack, contact
McIntosh for additional assistance.
Sensor Connections:
6. Connect an external Sensor to the McIntosh
MEN220 IR IN Jack.
Audio Connections:
7. Connect Balanced Cables from the McIntosh
MEN220 BALanced AUDIO INPUT Connectors
to the Preamplifier or A/V Control Center Bal-
anced Output Jacks.
Notes: 1. The Unbalanced Outputs on the MEN220
may be used instead of the Balanced Con-
nections.
2. By default the Unbalanced Inputs are
the active Connections. To use the Bal-
anced Inputs instead, it is first necessary
to change the default setting using the
MEN220 Setup Mode. Refer to pages 17
and 18.
8. Connect a Balanced Cable from the MEN220 Bal-
anced AUDIO OUTPUT (1) R Connector to the
Power Amplifier 1 Balanced Input Connector.
Note: The Unbalanced and Balanced Output Con-
nections are both active and may be used at
the same time.
9. Connect a Balanced Cable from the MEN220 Bal-
anced AUDIO OUTPUT (1) L Connector to the
Power Amplifier 2 Balanced Input Connector.
Loudspeaker Connections:
10. Refer to the Owner’s Manuals supplied with the
Power Amplifier and Loudspeakers for connection
information.
AC Power Cords Connections:
11. Connect the McIntosh MEN220 AC Power Cord to
a live AC outlet.
Loading ...
Loading ...
Loading ...