Loading ...
Loading ...
Loading ...
22
The MEN220 Advanced Settings include Remote
Control, Display, Software Version and Factory Reset.
REMOTE CONTROL:
1. Press the MENU Push-button to enter the Setup
Mode. Refer to figure 16 on page 18.
2. Rotate the NAVIGATE Control (or use the Direc-
tional ▲ ▼ Push-buttons on the Remote Control)
to select “Advanced Settings”. Refer to figure 50.
3. Press the SELECT Push-button and the “Advanced
Settings, Remote Control” will appear. Refer to
figure 51.
4. Press the SELECT Push-button and the default
Remote Control Setting will appear. Refer to
figure 52.
In a typical Audio/Video System, the MEN220 Power
Control and Data Port Connections are made to the
Audio Preamplifier or A/V Control Center. This al-
lows the MEN220 to switch On or Off with the Audio
Preamplifier or A/V Control Center. The commands
coming from the Remote Control (supplied with
the MEN220) are received by the Audio Preampli-
fier or A/V Control Center and are passed on to the
MEN220. The MEN220 Front Panel Sensor needs to
Advanced Settings
Figure 51
Advanced Settings
Remote Control >
Figure 50
MEN220 Setup Menu
< Advanced Settings >
Figure 52
Front Panel Sensor
On
In the ideal audio system the Left and Right Loud-
speakers would have the same measured distance to
the Focus Listening Position. Due to room dimen-
sions, funiture placements, etc. the distances may
not be identical. The MEN220 can delay the sound
coming from the closer Loudspeaker, assuring the
sound arrives at the same time to the Focus Listening
Position. Perform the following steps to correct for
different distannces:
7. First measure the actual distance from each Loud-
speaker to the Focus Listening Position.
8. Press the SELECT Push-button, then rotate the
NAVIGATE Control (or use the Directional ▲
▼ Push-buttons on the Remote Control) to posi-
tion the cursor and the ADJUST Control (or use
the Directional ▲ ▼ Push-buttons on the Remote
Control) to enter the distance (0-999) in inches or
centimeters. Refer to figures 47, 48 and 49.
L1 0” R1 0”
Out2 (Mono): 0”
Figure 49
L1 0” R1 0”
L2 0” R2 0”
Figure 47
L1 0cm R1 0cm
L2 0cm R2 0cm
Figure 48
Notes: 1. L1 and R1 are for Loudspeaker connected
to the Power Amplifier 1 (Power Amplifier
1 is connected to the MEN220 Output 1).
2. L2 and R2 are for Loudspeakers con-
nected to the Power Amplifier 2 (Power
Amplifier 2 is connected to the MEN220
Output 2).
3. When the MEN220 Electronic Crossover
is configured for Low Pass Mono on Out-
put 2 and two Subwoofers are connected,
measure the distance to each Subwoofer.
Then add together both distances and di-
vide by two for the distance measurement
for Output 2 (Mono).
Loading ...
Loading ...
Loading ...