Loading ...
Loading ...
Loading ...
FLUSH INSTALLATION
After checking that the
position of the hob is correct
fill the gap between the
worktop and the hob with
silicone adhesive. Flatten
the silicone layer with a
scraper or with wet finger
damped with water and soap
before it forms.
Do not use the hob until the silicone layer it is completely
dry.
Awatertight seal gasket is supplied with the hob. Fit the seal
gasket around the bottom hob as described and make sure
that it is properly fitted to avoid any leakage into the
supporting furniture.
4 ELECTRICAL CONNECTION.
06 GB- IE
When installing an oven under the hob, separator must not
be put and the minimum distance between the bottom part
of the hob and the oven must not be lower than 10 mm. Do
not install not cooled oven under this hob and install the
oven following its own installation requirements.
10 mm
min
Bottom
Normal Fixing:
- Get the fixing clips from accessory bag and screw them
into the position shown on bottom box. (Do not tighten the
screws to block clips, they should move freely)
- Insert the hob in center position of cut out.
- Turn the clips and tighten them fully.
Quick Fixing: (Depending on model)
Get four springs form accesory bag and screw them onto
bottom box as shown in figure.
Center and insert the hob.
Press the sides of hob until it is supported around its entire
perimeter.
1000+700 W
1000+700 W
1500+900 W 1200 W
1050+900+750 W
1050+900+750 W
1200 W
1200 W
1200 W
1800 W
1200 W
1200 W
1800 W
1000+700 W
-
-
1800 W
1800 W
B
CD
BA
C
B
C
D
A
C
B
B
D
A
LAY OUT 1 LAY OUT 2 LAY OUT 3
LAY OUT 4 LAY OUT 5
A A
C
Loading ...
Loading ...
Loading ...