Loading ...
Loading ...
Loading ...
Leave a distance of at
least 55 mm between the
hob and the back wall and
of at least 150 mm
between the hob and the
vertical furniture or walls in
the lateral side. If a
furniture is installed above
the hob, the minimum
distance required is 700
mm.
When installing a hood
above the hob, please
consult the installation
requirements specified for
the hood but, in any case,
the distance between the
hob and the hood must not
be lower than 700 mm.
PRODUCT CODE T
Identification Plate (located under the hob's bottom casing)
1. GENERAL WARNINGS
By placing the mark on this appliance we are assuring
compliance to all European Safety, Health and
Environment requirements which are applicable for this
product category.
2. PROTECTION OF THE ENVIRONMENT
This appliance is marked according to European
Directive 2012/19/EU on Waste Electrical and
Electronic Equipment (WEEE).
WEEE contains both polluting substances (which
can cause negative consequences for the
environment) and basic components which can be
reused.It is important to have WEEE subjected to
specific treatments, in order to remove and dispose
properly all pollutants and recover and recycle all
materials.
Individuals can play an important role in ensuring that the WEEE
does not become an environmental issue; it is essential to follow
some basic rules:
• WEEE shall not be threatened as household waste.
• WEEE shall be handled over to the relevant collection points
managed by the municipality or by registered companies. In many
Countries, for large WEEE, home collection could be present.
• In many Countries, when you buy a new appliance, the old one
may be returned to the retailer who has to collect it free of charge on
a one-to-one basis, as long as the appliance is of equivalent
typology and has the same functions as the supplied one.
3 INSTALLATION.
Installing a domestic appliance it is a complicated operation
which, if not carried out correctly, can seriously have impact
on safety of goods, properties or persons. For this reason, it
should be carried out by a professionally qualified person in
accordance with technical regulations.
In the event that this advice it is ignored and installation is
carried out by an unqualified person, the Manufacturer
declines all responsibility for any technical failure of the
appliance whether or not it results in damage of goods or
properties or in injury of persons or animals.
After having removed the packaging please be sure that the
appliance it is not damaged, otherwise contact the Retailer
or Manufacturer After Sales Service.
Make sure that the furniture in which the appliance will be fitted
and all other furniture in the nearby are made with materials
which can withstand high temperatures (min 100 °C).
In addition, all decorative laminates should be fixed with high-
resistance glue.
Appliance can be installed in a Built-in furniture in
“Standard” or “Flush” mode.
05 GB- IE
700 mm
55 mm
150 mm
490 mm
+ 2
- 0
560 mm
+ 2
- 0
Min. 70 mm
Standard installation
perimeter
Note: Inner perimeter dimensions are same with standard installation
703 mm (70 cm hob)
+2
-0
523 mm
+ 2
- 0
593 mm (60 cm hob)
+2
-0
Slot depth: 5 mm
Flush installation
perimeter
Worktop thickness should be between 25 and 45 mm.
If the bottom part of the hob is adjacent to an area normally
accessible for handling or cleaning operations, a separator
it must be put 0 mm below the bottom part of the hob.2
min 20 mm
Loading ...
Loading ...
Loading ...