Loading ...
Loading ...
Loading ...
26
NS-TWM16WH9
www.insigniaproducts.com
2 Open the lid of the washer, then pour water into the tub to the leveling circle.
If the washer is level the water will touch the leveling circle all the way around.
If the washer is not level, the water will only touch part of the leveling circle.
3 If your washer is not level, carefully tilt your washer just enough to adjust the
leveling foot on the bottom left of your washer. Extend the foot only as much
as is necessary. If the foot is extended too much, your washer may vibrate.
Step 7: Power your washer
Plug the power cord into a well-grounded, 3-prong,
120 Volt 60Hz approved electrical outlet, protected by
a 15-amp fuse or comparable circuit breaker. Your
washer is grounded through the third prong of the
power cord.
Leveling circle
Washer is level - the water
touches the leveling circle
all the way around.
Washer not level - the water
does not touch the leveling
circle all the way around.
Add water to the washer until it reaches
the leveling circle. If the washer is level, the
water will touch the leveling circle all the
way around. If it’s not level, it will only
touch part of the leveling circle.
Loosen
Lock
Level
Loading ...
Loading ...
Loading ...