Loading ...
Loading ...
Loading ...
Part Number 000014141 Rev06 9/19 45
Section 4 Maintenance
Step 4 Wait until the cycle is complete
(approximately 24 minutes). Then
disconnect power to the ice machine (and
dispenser when used).
n
Warning
Disconnect the electric power to the ice
machine at the electric service switch box.
Step 5 Remove parts for descaling.
Refer to parts removal page 46. Continue
with Step 6 when the parts have been
removed.
Step 6 Mix a solution of cleaner/descaler
and lukewarm water. Depending upon
the amount of mineral buildup, a larger
quantity of solution may be required. Use
the ratio in the table below to mix enough
solution to thoroughly descale all parts.
Solution
Type
Water Mixed With
Cleaner/
Descaler
1 gal (4 L)
16 oz
(475 ml)
cleaner/descaler
Step 7 Use half of the cleaner/descaler
& water mixture to descale all components.
The solution will foam when it contacts
lime scale and mineral deposits; once the
foaming stops, use a soft-bristle nylon
brush, sponge or cloth (NOT a wire brush)
to carefully descale the parts. Soak parts
for 5 minutes (15 - 20 minutes for heavily
scaled parts). Rinse all components with
clean water.
Step 8 While components are soaking,
use half of the solution to descale all food
zone surfaces of the ice machine and bin
(or dispenser). Use a nylon brush or cloth
to thoroughly descale the following ice
machine areas:
• Side walls
• Base (area above water trough)
• Evaporator plastic parts - including top,
bottom and sides
• Bin or dispenser
Rinse all areas thoroughly with clean water.
SANITIZING PROCEDURE
Step 9 Mix a solution of sanitizer and
lukewarm water.
Solution
Type
Water Mixed With
Sanitizer 3 gal (12 L)
2 oz
(60 ml)
sanitizer
Step 10 Use half of the sanitizer/
water solution to sanitize all removed
components. Use a spray bottle to liberally
apply the solution to all surfaces of the
removed parts or soak the removed parts
in the sanitizer/water solution. Do not rinse
parts after sanitizing.
Loading ...
Loading ...
Loading ...