Loading ...
Loading ...
Loading ...
Part Number 000014141 Rev06 9/19 17
Section 2 Installation
Bin Installation
NOTE: When using casters, the units must
be tethered or secured to comply with all
applicable codes. Swivel casters must be
mounted on the front and rigid casters
must be mounted on the rear. Lock the
front casters after installation is complete.
1. Remove threaded plug from drain
fitting.
2. Screw the leveling legs onto the
bottom of the bin.
3. Screw the foot of each leg in as far as
possible.
4. Move the bin into its final position.
5. Level the bin to assure that the bin
door closes and seals properly. Use a
level on top of the bin. Turn the base
of each foot as necessary to level the
bin.
6. Inspect bin gasket prior to ice machine
installation. (Manitowoc bins come
with a closed cell foam gasket installed
along the top surface of the bin.)
7. Remove all panels from ice machine
before lifting and installing on bin.
Remove front panel, top cover, left and
right side panels.
Dispenser Installation
Observe following recommendations unless
required by the dispenser manufacturer.
• An adapter is not required for ice
machines that match the dispenser size.
• A deflector is not required.
• Ice level management is recommended
to prevent water leakage or movement
of ice machine during agitation.
• Align sides and back of ice machine with
sides and back of dispenser when placing
ice machine.
• Follow ice machine installation
procedures in this manual and any
additional installation requirements
specified by the dispenser manufacturer.
Loading ...
Loading ...
Loading ...