Loading ...
Loading ...
Loading ...
Part Number 000014141 Rev06 9/19 41
Section 3 Operation
Minimum/Maximum Slab Weight
Adjust ice thickness to meet chart
specifications.
Model
Minimum
Ice Weight
Per Cycle
lbs
Grams
Maximum
Ice Weight
Per Cycle
lbs
Grams
IF0300
2.40 lbs
1089 grams
2.80 lbs
1270 grams
IT0420 IT0450
IP0520 IT0620C
3.40 lbs
1542 grams
3.90 lbs
1769 grams
IT0500 IF0500
IP0500
4.60 lbs
2087 grams
5.20 lbs
2359 grams
IF0600 IT0750
4.12 lbs
1869 grams
4.75 lbs
2155 grams
IBF0820C
5.75 lbs
2608 grams
6.50 lbs
2948 grams
IF0900 IT0900
6.20 lbs
2812 grams
7.20 lbs
3266 grams
IT1200
IBT1020C
7.50 lbs
3402 grams
8.20 lbs
3719 grams
IF1400C
12.00 lbs
5443 grams
14.00 lbs
6350 grams
IT1500
13.20 lbs
4649 grams
14.80 lbs
5216 grams
IF1800C
15.5 lbs
7031 grams
16.75 lbs
7598 grams
IT1900
13.20 lbs
5987 grams
14.80 lbs
6713 grams
IF2100C
16.00 lbs
7257 grams
17.25 lbs
7824 grams
Important
Routine adjustments and maintenance
procedures are not covered by the
warranty.
Ice Thickness Check
After a harvest cycle, inspect the ice cubes
in the ice storage bin. The ice thickness
probe is factory-set to maintain the ice
bridge thickness at 1/8" (3 mm).
NOTE: Make sure the water curtain is
in place when performing this check. It
prevents water from splashing out of the
water trough.
1. Inspect the bridge connecting the
cubes. It must be approximately
1/8" (3 mm) thick.
2. If adjustment is necessary, turn the
ice thickness probe adjustment screw
clockwise to increase bridge thickness,
counterclockwise to decrease bridge
thickness. Set a 7 mm (9/32") gap
between ice thickness probe and
evaporator as starting point, then
adjust to achieve a 1/8" (3 mm) bridge
thickness.
NOTE: Turning the adjustment one-third of
a turn will change the ice thickness about
1/16" (1.5 mm).
1/8" (3 mm)
ICE BRIDGE THICKNESS
PLACE 9/32"
(7 mm) DRILL BIT
BETWEEN PROBE AND
EVAPORATOR TO SET
INITIAL GAP
ADJUSTING SCREW
Verify the ice thickness probe wire doesn’t
restrict probe movement.
Loading ...
Loading ...
Loading ...