Loading ...
Loading ...
Loading ...
4. Loosen the CO2 bottle sheath (Show as figure 15), insert a non-threaded 16 gram
CO2 cartridge in the sheath (Figure 16), and screw the sheath tightly until you hear it
“click” or “pop” (Figure 17), which indicates that the cartridge seal has been pierced
and the CO2 gas can flow into the keg freely. Make sure the CO2 bottle sheath is fixed
tightly to avoid CO2 leakage. Then put CO2 bottle sheath into the top cover.
Figure 15 Figure16
Figure 17 Figure 18
5. Close the top cover of the beer cooler. When dispensing beer, turn the knob on the
top cover to “+” position to release the CO2 (you will hear a hissing noise). When
done, turn knob back to “-“ position to close the CO2. Please refer to the notice label on
the top cover.
6. Turn on the power switch to “I” position to power on the beer cooler. (“0” position is
off).
NOTES:
Please make sure your hands are dry when you operate the beer cooler, to
avoid electric shock.
Figure 19
2． Switch is on ‘off” status
1． Connector
16gCO2
CO2 bottle
sheath
Regulator assembly
Cover assembly
Loading ...
Loading ...
Loading ...