Loading ...
Loading ...
Loading ...
Figure 24 Figure 25
3. Close the top cover; operate it as above step 6-12, as the universal 5 liter keg, but
step 9 is exception.
D
、
、、
、
TO CHANGE A NEW BEER KEG
(5 liter universal keg)
When the beer keg runs out follow the instructions below before installing a new
beer keg.
1． Adjust the CO2 pressure regulation knob to “-“ switch to shut off the CO2 supply
and reserve the CO2.
2． Open the top cover of the beer cooler, pull down the tap handle to release the
remaining gas in the keg (there may be some beer bubble).
3． Disconnect the CO2 and Beer connectors from the Piercing Pin/Keg Lifter by
pressing the white release buttons as shown on figure 26.
4．Use the keg lifter and remove the keg from the dispenser.
5．Disconnect the piercing pin from the keg (see figure 27).
6． It is recommended to clean the tap mechanism when changing the beer keg each
time. Please refer to the below contents about cleaning.
7. Follow installation instructions for new keg.
Beer
connector
Note: Please take out the Heineken adaptor with
collect ways, Press it according the arrow
indication, or will damage the fastener
Loading ...
Loading ...
Loading ...