Loading ...
Loading ...
Loading ...
16 Assembling and Maintaining the StretchTrainer
2. Slide a foot rest onto one end of the axle.
3. Position an E-clip from the hardware kit on the foot rest as
shown in the following figure and push it into position.
Note: A notch has been cut into the axle to position the
E-clip. You may need pliers to push the E-clip into
position.
Figure 10: Position of E-clip on the foot rest
4. Slide a foot rest onto the other side of the axle and repeat
step 3.
5. After the foot rests are securely fastened to the axle,
check that the axle is centered through the seat frame.
Then tighten the two small set screws that hold the axle
in position using a 3mm hex wrench.
Note: Do not overtighten the screws.
Figure 11: Tighten set screws on axle
Loading ...
Loading ...
Loading ...