Loading ...
Loading ...
Loading ...
13
www.udirc.com
Altitude Hold Mode
Altitude hold mode indicates that the drone maintains a consistent altitude while
allowing roll, pitch, and yaw to be controlled normally. It makes it easier to
control the drone for beginner and more stable for aerial photography.
Take off/ One button take off/Landing modes
Functions Introduction
2. One Button Take Off: After frequency pairing successful
or motors activated, press the Take Off / Landing /
Emergency Stop Button (Picture 13), the drone will fly
up automatically and keep flying at the altitude of 1.2
meters approximately.
1. Take off: After frequency pairing successful, push the Left Stick and Right Stick
as Picture 12 shown (45 degree inward) to start the motors and then release.
Then push up the Left Stick to fly up the drone to
certain altitude and then release the stick.
▲Emergency Stop: When the drone in emergency situation and going to hit the walking
people or obstacle etc., press the Take Off / Landing / Emergency Stop Button
immediately and hold it for more than 1s( picture 16). The propellers will stop
immediately and land on the ground directly.
3. Landing: When flying, push the Left Stick all the way
down to the lowest position (Picture 16) and hold it till
the motors stop and the drone will land on the ground
slowly.
4. One Button Landing: When flying, press the Take Off / Landing / Emergency
Stop Button once shortly (picture 16), and the drone will land on the ground
automatically. (When using this function, you can not touch the left stick,
otherwise, then the function will fail)
Take Off / Landing /
Emergency Stop Button
Picture 16
Left and right turning trimmer
When take off, if the drone head rotates to left,then press down the
trimmer button and push the left stick to right. Otherwise push to left.
Forward and backward trimmer
When take off, if the drone tilts forward, press down the trimmer button,
and push the right stick backwards. Otherwise push forwards.
Left and right side flying trimmer
When take off, if the drone tilts to left, then press and hold the trimmer
button and push the right stick to right. Otherwise push to left.
Trimmer mode
Loading ...
Loading ...
Loading ...