Loading ...
Loading ...
Loading ...
Wireless temperature sensor en
37
■ The cooking functions are made available once the
temperature sensor has been connected to the
control panel correctly.
■ If there is a fault with the temperature sensor, the
connection may not be established correctly for the
following reasons:
– Bluetooth communication error.
– You did not press the symbol on the temperature
sensor within 30 seconds of selecting a hotplate.
– The battery in the temperature sensor has run
out.
Reset the wireless temperature sensor and follow
the connection procedure once again.
■ If the temperature sensor and the control panel are
not connected correctly due to a transmission error,
follow the connection procedure once again.
If the display continues to show incorrect connection
‚, contact our technical after-sales service.
Resetting the wireless temperature sensor
1. Touch and hold the å symbol for approximately 8-
10 seconds.
While you are doing this, the temperature sensor's
LED indicator will light up three times. When the LED
lights up for the third time, it will start to reset the
temperature sensor. At this point, you will need to lift
your finger off the symbol.
Once the LED goes out, this means that the wireless
temperature sensor has been reset.
2. Repeat the connection procedure from point 2.
Cleaning
Do not clean the wireless temperature sensor in the
dishwasher.
Temperature sensor
Clean the temperature sensor with a damp cloth. Never
clean it in the dishwasher. Do not immerse it in water or
clean it under running water.
Remove the temperature sensor from the saucepan
after cooking. Store it in a clean, safe place (such as in
its packaging) away from sources of heat.
Silicone patch
Clean and dry before attaching to the temperature
sensor. Dishwasher safe.
Note: Cookware with the silicone patch must not be left
to soak for long periods in soapy water.
Temperature sensor window
The sensor window must always be clean and dry.
Proceed as follows:
■ Remove dirt and oil splatters regularly.
■ Use a soft cloth or cotton buds and window cleaner
for cleaning.
Notes
■ Do not use abrasive cleaning agents such as
scouring pads, scrubbing brushes or cream
cleaners.
■ Do not touch the sensor window with your fingers.
This may make it dirty or scratch it.
Changing the battery
Changi ng the bat t er y
If the temperature sensor does not light up when the
symbol is pressed, the battery is flat.
Changing the battery:
1. Remove the silicone cover from the lower section of
the temperature sensor housing and remove both
screws using a screwdriver.
2. Open the closure of the temperature sensor.
Remove the battery from the lower section of the
housing and insert a new battery (pay attention to
the correct orientation of the battery poles).
Loading ...
Loading ...
Loading ...