Loading ...
Loading ...
Loading ...
Hinge
lock
Slot
29
GEAppliances.ca
Operating Instructions
Care and Cleaning Troubleshooting Tips
Consumer Support
.
The door is very heavy. Be careful when
removing and lifting the door.
Do not lift the door by the handle.
To remove the door:
Fully open the door.
Pull the hinge locks down toward the door
frame, to the unlocked position. A tool,
such as a small flat-blade screwdriver,
may be required.
Firmly grasp both sides of the door
at the top.
Close door to the door removal position,
which is halfway between the broil stop
position and fully closed.
Lift door up and out until the hinge arm
is clear of the slot.
To replace the door:
Firmly grasp both sides of the door
at the top.
With the
door at the
same angle
as the removal
position, seat the
indentation of the
hinge arm into the
bottom edge of the
the slot.
Fully open the door. If the door will not
fully open, the indentation is not seated
correctly in the bottom edge of the slot.
Lift-Off Oven Door (on some models)
Hinge
lock
Indentation
edge of
slot
Push hinge locks up to lock.
Hinge arm
Hinge
arm
Close the oven door.
Push the hinge locks up against the front
frame of the oven cavity to the locked
position.
hinge slot. The notch in the hinge arm
must be fully seated into the bottom of
Bottom
S ety nstructio saf I n
Pull hinge locks down to unlock.
Removal position
The oven door is removable for cleaning.
Do not lift the door by the handle. Make sure
the oven is completely cool.
To remove the door, open it to the special
stop position. Grasp firmly on each side and
lift the door straight up and off the hinges.
Do not place hands between the hinge
and the oven door frame.
To replace the door, make sure the hinges
are in the special stop position. Position
the slots in the bottom of the door squarely
over the hinges and slowly lower it over both
hinges.
To clean the inside of the door:
Do not allow excess water to run into
Lift the door straight up and o
the hinges.
Lift-Off Oven Door for JCBS250 model
GEAppliances.ca
Loading ...
Loading ...
Loading ...