Loading ...
Loading ...
Loading ...
Consumer Support Troub leshooting Tips
Care and Cleaning
Operating Instructions
Safety Instructions
CLOCK
HORLOGE
Make sure the clock is set to the
correct time of day.
TIMER
MINUTERIE
The Timer is a minute timer only.
The Timer does not control oven
operations. The maximum setting on
the Timer is 9 hoursand 59 minutes.
16
Using the clock, timer and convenience outlet.
To Set the Clock
The clock must be set to the correct time
of day for the automatic oven timing
functions to work properly. The time of
day cannot be changed during a timed
baking or self-cleaning cycle.
Touch the
CLOCK
pad.
Touch the number pads.
Touch the
START
pad.
To Set the Timer
Tou ch the
TIMER
pad.
Touch the number pads until the
amount of time you want shows
in the display. For example, to set
2 hours and 45minutes, touch
and If youmake a
mistake, touch the pad and
begin again.
2, 4
TIMER
TIMER
5 in that order.
Touch the pad.
START
After touching the
START
pad,
SET
disappears;
this tells you the time is counting down, although
the display does not change until one minute has
passed. Seconds will not be shown in the display
until the last minute is counting down.
When the Timer reaches :00, the
control will beep 3 times followed by
one beep every 6 seconds until the
pad is touched.
The 6-second tone can be canceled by following
the steps in the Special features of your oven
control section under Tones at the End of a
Timed Cycle.
To Reset the Timer
If the display is still showing the time
remaining, you may change it by
touching the
TIMER
pad, then touch
the number pads until the time you
want appears in the display.
If the remaining time is not in the display
(clock, delay start or cooking time are in
the display), recall the remaining time
by touching the
TIMER
pad and then
touching the number pads to enter the
new time you want.
To CanceltheTimer
Touch the
TIMER
pad twi ce.
Convenience Outlet
(on some models)
The 120V convenience outlet located on
the top of the backguard may be used to
plug in small electrical appliances.
When using the outlet, be sure that the
electrical cord does not rest on or near a
surface unit. If the surface unit is turned
on, the cord will be damaged.
To reset the circuit breaker, press the
switch located near the outlet on top of
the backguard.
Loading ...
Loading ...
Loading ...