Loading ...
Loading ...
Loading ...
22
En
Preparation
05
Attaching/detaching the PIONEER stand
(for PRO-940HD only)
The PRO-940HD comes with the PIONEER table top stand
attached. You can mount the display in a rack by detaching the
stand. The method for attaching/detaching the stand varies
depending on the particular panel.
CAUTION
• If mounting the panel on a stand, use only the attached
stand for this model. Other stand models are not authorized
for this panel.
• Two or more people are required to assemble and install this
unit.
Detaching the stand
1 Loosen the two installation bolts ➀ using the enclosed
hexagonal wrench.
2 Remove the two installation bolts ➁ using the same
hexagonal wrench.
3 Lift the Plasma Display from the stand.
• Keep the installation bolts ➀ and ➁ for reattaching the
stand to the Plasma Display at a later date.
NOTE
• Install the panel on a flat, stable location to avoid warping the
glass components.
Reattaching the stand
1 Fit the stand’s support columns under the Plasma Display
shown below. Slowly ease the panel down on the
supports.
• Be extremely careful not to insert the stand supports
into any part of the Plasma Display other than the stand
insertion slots. If the panel is mounted improperly, the
communication ports could be damaged or the stand
could be warped.
2 Bolt the Plasma Display to the stand at the points
indicated by the arrows.
3 Tighten the installation bolts ➀ firmly using the enclosed
hexagonal wrench.
NOTE
• Install the panel on a flat, stable location to avoid warping the
glass components.
• Insert the screws in the holes vertically.
• Do not tighten them with more force than necessary.
Installation bolts
➀
(M8 x 30 mm: silver)
Installation bolts
➁
(M8 x 60 mm: silver)
Line up the column supports with
the bottom of the Plasma Display .
Installation bolts
➁
(M8 x 60 mm: silver)
Installation bolts
➀
(M8 x 30 mm: silver)
PDP_PRO1540HD.book Page 22 Wednesday, August 2, 2006 6:01 PM
Loading ...
Loading ...
Loading ...