Loading ...
Loading ...
Loading ...
21
En
Preparation
05
English
Preventing the Plasma Display from
Falling Over
During installation, someone must steady the panel at all
times.
Stabilizing on a table or floor
Stabilize the Plasma Display as shown in the diagram using
screws that are 6 mm (1/4 inch) and at least 20 mm (13/16 inch)
long (available from your dealer or other hardware sources).
CAUTION
The installation site should have adequate strength to support
the Plasma Display. A weak installation site could result in
personal injury and property damage. Please take the
necessary safety measures to prevent it from falling during
emergencies, such as earthquakes or construction accidents.
If you do not take these precautions, the Plasma Display could
fall, causing injury or property damage.
Screws, hooks, chains, and other fittings used to secure the
Plasma Display vary according to the composition and
thickness of the surface to which the panel is attached. Inspect
the mounting surface carefully to determine its thickness and
composition; consult a professional installer if necessary.
Using a wall for stabilization
1. Attach fall-prevention bolts (hooks) to the
Plasma Display.
2. Use strong cords to firmly attach the panel
to a wall, pillar, or other sturdy
construction.
3. Repeat attachment for the other side of the
panel.
NOTE
Use hooks, cords, and fittings that are available from your
dealer or other hardware sources.
Recommended hook: Nominal diameter 8 mm (3/8 inch)
Length 12 mm to 15 mm (1/2 inch to 5/8 inch)
20 mm min.
(13/16 inch min.)
9 mm to 15 mm
(3/8 inch to 5/8 inch)
6 mm
(1/4 inch)
12 mm to 15 mm
(1/2 inch to 5/8 inch)
M8
➀
Hook
➁
Cord
Fitting
PDP_PRO1540HD.book Page 21 Wednesday, August 2, 2006 6:01 PM
Loading ...
Loading ...
Loading ...