Loading ...
Loading ...
Loading ...
INSTALLATION INSTRUCTIONS
Step 4-5. Wiring Remote Blowers (HYEX or ATEX)
ELECTRICAL CONNECTIONS
1. Run a 3-conductor electrical cable between the
blower and the range hood. Local building codes
take precedence, but unless otherwise directed,
use 14-2 MC shielded cable or equivalent. See
Figure 4.
2. Connect cable to terminal block on blower at
proper locations. For ATEX blowers, use Figure 5.
For HYEX blowers, use Figure 6.
3. Connect electrical cable from blower to the three-
position terminal block on the hood’s wire harness.
See Figure 7. [NOTE: Depending on your site-
specific installation, this step may need to be done
later in the overall installation process to allow for
proper wire routing through the hood shell.]
Figure 4 Cable between Hood and Remote Blower
LINE/Black
NEUTRAL/White
GROUND/Green-Yellow or Bare
Range Hood
Connect remote
blower to hood
harness via a
3-conductor cable.
ATEX
Blower
HYEX Blower
OR
Figure 5 ATEX Blower Connection
Figure 6 HYEX Blower Connection
Figure 7 Connection to control cable in hood
Out to Blower:
LINE/Black
GROUND/Green/Yellow/Bare
NEUTRAL/White
From hood harness:
LINE/Brown (or Black)
GROUND/Green/Yellow/Bare
NEUTRAL/Red (or White)
Motor
Leads
Cable in
from hood
Cable in
from hood
Motor
Leads
12
Turn off power at the service panel prior to wiring the
blower.
WARNING
!
Loading ...
Loading ...
Loading ...