Loading ...
Loading ...
Loading ...
63
ALL MODELS
F Cabinet Level: Ensure the appliance is level and dimensions accurate.
Refer to 'Cabinetry Dimensions, pages 14-15'.
F Anti-tip: Ensure the appliance is securely supported to the cabinetry with the supplied
anti-tip bracket and fittings. Refer to 'Cavity preparation, page 30'
F Door panel/and toe kick: Ensure door panel/s and toe kick are attached securely
and properly aligned; Refer to 'Install door panel, pages 42-44 and 'Install toe kick',
pages 44-45.
F Doors closing freely: Ensure the door/drawer can open and close freely with no
resistance from surrounding cabinetry or product. Refer to 'Door clearance' and 'Drawer
clearance', page 21.
F Hinge pin: Ensure hinge limiting pin is fitted for 90° door swing. Refer to 'Door
clearance', page 21.
F Vent clearance: Ensure the cabinet installation provides the minimum vent clearance
required. Check that the gap between the bottom of the door panel and the ground is at
least 50mm. Refer to 'Product dimensions', page 13.
F Cabinet trims: Ensure the cabinet side trims are securely attached. Refer to 'Install
cabinet trims', page 48.
F Door covers & trims: Ensure the door trims, door covers, and hinge pocket cover are
securely attached. Refer to "Installl Door Covers & Trims", page 49, and "Install Top Trim
& Hinge Pocket Covers", page 50.
Complete and keep for safe reference:
Model _____________________________________________________________
Serial No. _____________________________________________________________
Purchase Date _____________________________________________________________
Purchaser _____________________________________________________________
Dealer Address _____________________________________________________________
Installer’s Name _____________________________________________________________
Installer’s Signature _____________________________________________________________
Installation Company _____________________________________________________________
Installation Date _____________________________________________________________
FINAL CHECKLIST
TO BE COMPLETED BY THE INSTALLER
F Door opening sensor: Ensure the magnets at door are in place so door opening sensor
works properly. Refer to 'Install trims', page 47.
F Packaging: Ensure all internal and external packaging has been removed. Refer to 'Before
installation', page 27.
F Installation mode: Ensure the Installation Mode is de-activated (hold on Compartment
button for 4 sec. Refer to 'Power and water supply connection', page 35.
F Fault codes: Ensure no error codes are shown.
F User guide: Check the User Guide is inside the product in a visible area for the customer.
FOR PRODUCTS WITH ICE ONLY, WATER ONLY OR ICE & WATER FUNCTION
F Water filter: Water filter is installed and engaged in a horizontal position. Refer to 'Install
water filter', page 39.
F Ice maker: Turn ice maker ON. Force a manual ice maker cycle by pressing
the , and buttons together for four seconds then close the door(s). The ice tray
will turn over and activate the valve. Repeat force manual ice maker cycle. The ice tray
will fill and empty into the bin below, dry the bin and return it correctly. Refer to page 19
of your User Guide.
F Dispenser: Ensure the water is flowing through the system using the dispenser pad. Refer
to page 18 of your User Guide.
Loading ...