Loading ...
Loading ...
Loading ...
5
SAFETY AND WARNINGS
INSTALLATION
z
The anti-tip bracket and fittings supplied must be fitted tothe wall of the finished
enclosure to withstand a 220lbs (100kg) load.
z
Ensure that the anti-tip bracket is installed correctly to prevent the possibility of the
appliance tipping forward when the door is open.
z
Ensure the door of the appliance is closed when rolling into thecabinetry.
z
Ensure the power cord is not run over or damaged when rolling the product into
the cabinetry.
z
For flush installation, ensure the door panels are installed flush with cabinetry front surface.
Ensure the appliance is properly centered.
z
All four corners of the appliance must be supported firmly on the floor to eliminate any
movement. Installing the appliance on a soft, uneven, or not level floor may cause twisting
and poor door sealing.
z
Use low speed, low torque setting when using a powered driver for the screws when fixing
or aligning the product.
z
Open the appliance door to remove the alignment brackets from both sides of the
appliance, and then re-tighten the screws.
z
When removing the top door extrusion, ensure the magnet remains in place and not
damaged as this will affect the operation of the appliance.
Stainless steel panel
z
Protect the finish of the Fisher and Paykel Stainless Steel door panels from any scratch
or damage.
z
Remove the blue tape attached to inner edges of the door panels after the handles are
installed.
z
We recommend to load the shelves in the appliance door with weights to ensure an
accurate door panel gap width. Load 33lbs (15kg) for 24" models, and 44lbs (20kg) for
30" models.
Custom panel
z
If using Custom door panels, ensure they are prepared as per 'Custom door panel install
dimensions' section.
z
The thickness of the custom door panel can vary as long as the screws do not penetrate
beyond the full depth of the door panel, and as long as the overall weight of door panel
does not exceed the allowable weight. Refer to 'Door panel dimensions' for maximum door
panel weight of your product.
z
Do not place the handle holes in marked areas to avoid clashing with panel
attachment brackets.
z
Minimum panel thickness where screw hole is drilled must be 5/8" (16mm).
Changing the door hinge (optional)
z
Door hinges are interchangeable for each model. A hinge change kit is available and can be
purchased separately if you prefer to change from ‘right hinge door’ to ‘left hinge door’ or
vice versa.
INTEGRATED REFRIGERATOR & FREEZER
Left or Right hinged door available for each model.
18" Freezer
RS1884FLJ1, RS1884FLJK1,
RS1884FRJ1 & RS1884FRJK1
24" Freezer
RS2484FLJ1, RS2484FLJK1,
RS2484FRJ1 & RS2484FRJK1
24" Refrigerator
RS2484SL1, RS2484SLK1,
RS2484SLHK1, RS2484SRHK1,
RS2484SR1 & RS2484SRK1
30" Freezer
RS3084FLJ1, RS3084FLJK1,
RS3084FRJ1 & RS3084FRJK1
30" Refrigerator
RS3084SL1, RS3084SLK1,
RS3084SLHK1, RS3084SRHK1,
RS3084SR1 & RS3084SRK1
Loading ...
Loading ...
Loading ...