Loading ...
Loading ...
Loading ...
17
<Push t Connector Type>
1
Firmly push the water tube connected from
the appliance into the end that has the arrow
pointing outward. Push the tube all the way in
(approx. 10 - 12 mm).
2
After inserting the tube securely into the lter,
t the locking clip into position under the pull
up collar.
3
Repeat on the other end of the lter using the
remainder of the water tube.
Connecting to the Water Tap
1
Push the water tube into the hole of the tap
connector supplied in the accessories. The
pipe should be held rmly whilst the connector
is pushed onto the pipe.
2
Ensure that the rubber washer is tted to the
inside of the tap connector before screwing it
onto the correct type tap.
Checking the Water Connection
1
Turn on the water supply and switch on the
appliance. Carefully check all ttings for
possible leaks due to poorly tted hoses.
2
Press and hold the Water Filter button for
three seconds. This will reset the Replacement
Filter icon. The new water lter has been
activated.
3
Place a cup under the water dispenser
to verify that water is owing throughthe
appliance. it is normal for cloudy water to
be dispensed until the air from the lter is
removed completely.
4
Check the connecting tube and joints for leaks
once again.
5
The water lter should be located in an
appropriate place where it is easy to reach for
replacement purposes.
Loading ...
Loading ...
Loading ...