Loading ...
Loading ...
Loading ...
34
Dishwasher seems to run a
long time.
Incoming water is not warm enough. Before starting a cycle, run hot water faucet at
the sink closest to the dishwasher.
Cycle time can vary due to soil and
water conditions.
Sensors in the dishwasher automatically
increase the cycle time to ensure a good wash
when heavy soil is detected.
Rinse aid dispenser 1j is empty.
Add rinse aid.
Dishwasher connected to cold
water supply.
Note: : Check the typical wash cycle
length.
Verify dishwasher is connected to hot water
supply plumbing.
Detergent residue.
Detergent dispenser cover 9"
blocked by dishes and therefore
does not open fully.
Dishes must not be placed above the deter-
gent tab tray 1:. These may block the lid of
the detergent dispenser and prevent it from
opening fully.
Do not place dishes or fragrance dispenser in
the detergent tab tray.
Detergent dispenser cover 9"
blocked by the detergent tab.
Detergent tab must be inserted flat and not
upright.
Detergent tab used in the quick or
short wash cycle.
Dissolving time of the detergent is
not reached in the selected short
wash cycle.
Dissolving time of detergent tab too long for a
quick or short wash cycle.
Use a detergent powder or select a more
intensive wash cycle.
Washing effect and dissolving per-
formance are reduced after a pro-
longed storage time or detergent is
very lumpy.
Change detergent.
Water stains on plastic parts. Droplet formation on plastic sur-
face is physically unavoidable. After
drying, water stains are visible.
Use a more intensive wash cycle (more water
changes).
Arrange dishes in a sloping position.
Use rinse aid.
If required, increase softening setting.
Washable or water-soluble
coatings in the container or
on the door.
Detergent substances are depos-
ited. These coatings cannot usually
be removed with chemicals (appli-
ance cleaner, ...).
Change detergent brand.
Clean appliance mechanically.
If there is a “white coating” on the
container floor, the water softening
system has been set very low.
Increase softening setting and change deter-
gent if required.
Salt dispenser cover 1R not
closed.
Close salt dispenser cover correctly.
Only for glasses: Initial glass corro-
sion – can only apparently be wiped
off.
See “Glass and silverware damage”.
White limescale on the
dishes, tub, racks or door.
White residue coats dishwasher
interior and racks wheels squeak
from lime scale deposits in hard
water.
Use dishwasher cleaner every few months.
If dishwasher has a water softener, increase
the setting.
Hard water kept 3 in 1 detergent or
bio/eco detergent from being effec-
tive.
Use separate dishwasher detergent, rinse aid
and dishwasher softener salt (if dishwasher
has a softener).
Underdosing of detergent. Use more detergent or change to a more
effective detergent.
Rinse temperature is too low. Select a more intensive wash cycles with
higher washing temperatures.
Fault Cause Remedial action
Loading ...
Loading ...
Loading ...