Loading ...
Loading ...
Loading ...
30
Spray arms
Limescale and contaminants in the rinsing water may
block nozzles and bearings on the spray arms
12
and 1J.
1.
Check outlet nozzles on the spray arms for blockages.
2.
Unscrew the upper spray arm 12 (1) and remove
downwards (2).
3.
Remove the lower spray arm 1J upwards.
4.
Clean spray arms under running water.
5.
Re-engage or screw on spray arms.
Drain pump
Large food remnants in the rinsing water not retained by
the filters may block the waste water pump. In this case:
9 WARNING
Use caution when removing parts for cleaning as
some debris may be sharp.
1.
Disconnect the appliance from the power supply.
2.
Take out upper rack 1" and lower rack 1b.
3.
Remove the filters 1Z.
4.
Scoop out standing water - use a sponge if necessary.
5.
Using a spoon, pry off the pump cover (as shown) until
it clicks, then grip the cover and pull upward until it
resists and then pull forward (1). Remove cover
completely.
6.
Check inner compartment and remove any foreign
objects.
9 WARNING
Use caution when removing parts for cleaning as
some debris may be sharp.
7.
Place pump cover in the original position (2) and
press down until it engages (3).
8.
Place cover in the original position, press down and
engage.
9.
Reinstall filters.
10.
Re-insert racks.
Note: The drain pump will not work properly if the drain
pump cover is not snapped in completely until it clicks.
&OLFN
Loading ...
Loading ...
Loading ...