Loading ...
Loading ...
Loading ...
33
Dishes not dry. No or too little rinse aid in the dis-
penser.
Refill rinse aid.
Wash cycle selected without drying. Select wash cycle with drying.
Water collecting in depressions on
the dishes and silverware.
Arrange dishes in a sloping position, arrange
affected dishes as sloping as possible.
The combined detergent used has a
poor drying performance.
Use different combination detergent with better
drying performance. Use of rinse aid also
increases the drying performance.
extraDry to increase drying not acti-
vated.
Activate extraDry.
Dishes were removed too early or
drying process had not ended yet.
Wait until wash cycle ends or wait until 30 min
after wash cycle ends before removing dishes.
The eco rinse aid used has a limited
drying performance.
Use a commercial brand of rinse aid. Eco
products may have limited effectiveness.
Plastic dishes not dry. Special properties of plastic. Plastics do not dry well because they do not
hold heat.
Silverware not dry. Silverware not arranged properly in
the silverware basket.
Separate silverware if possible, prevent con-
tact points.
Silverware not arranged properly in
the third rack.
Arrange silverware properly and separate if
possible.
Appliance interior wet after
rinse cycle.
No appliance fault. Dishwashers us “condensation drying,” where
humid air condenses on tub walls so it can
drain and be pumped out.
Food soils on the dishes. Dishes placed too closely together,
racks overfilled.
Arrange dishes with adequate clearance
between them ensuring that the spray jets can
reach the surface of the dishes. Prevent con-
tact points.
Spray arm rotation obstructed. Arrange dishes so that the spray arm can
rotate without obstruction.
Spray arm nozzles are blocked. Clean the spray arm nozzles.
Filters 1Z dirty.
Clean filters.
Filters 1Z inserted incorrectly and/
or not engaged.
Insert and engage filters correctly.
Rinse wash cycle too weak. Select a more intensive rinse cycle.
Increase sensitivity of the sensors.
Dishes precleaned too intensely;
sensors therefore decide on weak
wash cycle sequence. Stubborn
soiling cannot be completely
removed.
Do not prerinse dishes. Remove only large
food soils.
Increase sensitivity of the sensors.
Recommended wash cycle "Regular" or Inten-
sive.
Tall narrow containers in corner
areas are not rinsed adequately.
Do not tilt containers and do not place in the
corner area.
Upper rack 1" on right and left
not set to same height.
Set upper rack to same height using side
levers.
Fault Cause Remedial action
Loading ...
Loading ...
Loading ...