Loading ...
Loading ...
Loading ...
24
How to Operate the MCT500, con’t
Resetting the MCT500
FIRST PROCEDURE
In the unlikely event the MCT500 stops functioning,
first try resetting the Main (System) Microprocessor
by performing the following:
1. Switch Off the MCT500 by using the STANDBY/
ON Front Panel Push-button. Then simultaneously
press and hold in the Front Panel STANDBY/ON
and DISC LAYER Push-button until the illumina-
tion of the LED above the STANDBY/ON Push-
button goes Off.
2. Press the STAND/BY Push-button to switch the
MCT500 back On.
Notes: 1. Resetting of the microprocessor also places
the Power Saving Mode into the default set-
ting of On.
2. If the MCT500 is not performing normally,
perform the second procedure below.
SECOND PROCEDURE
If the MCT500 is still not functioning properly, reset
the Secondary (Transport) microprocessor by per-
forming the following:
1. Switch Off A.C. Power going to the MCT500.
Note: Temporarily, connect the AC Power Cord
coming from the MCT500 into an AC Power
Strip with an On/Off Switch. Position the
AC Power Strip so the On/Off Switch on
the strip is in very close proximity to the
MCT500 Front Panel NEXT and STOP
Push-buttons (the MCT500 Remote Control
STOP Push-button will not work for reset-
ting the micro).
2. Press and hold in the NEXT: and STOP< Push-
buttons while at the same time switching On the
AC Power Strip.
3. The Front Panel Display will indicate “INITIAL-
IZED” then release the NEXT: and the STOP<
Push-button.
4. When the Front Panel Display indicates “DISC” or
“NO DISC”, press the STANDBY/ON Push-button
to switch the MCT500 OFF. Now reconnect the
MCT500 AC Power Cord the way it was connected
before performing Step 1 Note, then switch the
MCT500 back On.
Loading ...
Loading ...
Loading ...