Loading ...
Loading ...
Loading ...
Switch the system back on, if needed.
Depending on the vehicle
equipment: switching on/off
manually
Press the park assistance button.
▷ On: the LED lights up.
▷ Off: the LED goes out.
The parking assistance functions are shown on
the Control Display.
Switching the view via iDrive
If the rearview camera view is not displayed,
change the view via iDrive:
1.
If necessary, tilt the controller to the side.
2. "Rear view camera"
The rearview camera image is displayed.
Functional requirements
▷ The rearview camera is switched on.
▷ The trunk lid is fully closed.
▷ Keep the recording range of the camera
clear. Protruding cargo or carrier systems that
are not connected to a trailer power socket
can restrict the visibility range of the camera.
Assistance functions
General information
More than one assistance function can be active
at the same time.
The assistance functions can be manually acti‐
vated.
1.
Move the Controller to the right, if needed.
2. With corresponding equipment:
"Camera image"
3.
▷ "Parking aid lines".
Pathway lines and turning radius lines are
displayed, refer to page 233.
▷ "Obstacle mark.".
Depending on the vehicle equipment, the
obstacles detected by PDC Park Distance
Control are displayed, refer to page 234,
by markings.
Parking aid lines
Pathway lines
Pathway lines help you to estimate the space re‐
quired when parking and maneuvering on level
roads.
Pathway lines depend on the steering angle and
are continuously adjusted to the steering wheel
movements.
Turning radius lines
Turning radius lines can only be superimposed
on the camera image together with pathway
lines.
Turning radius lines show the course of the
smallest possible turning radius on a level road.
Only one turning radius line is displayed after the
steering wheel is turned past a certain angle.
Seite 233
Driver assistance systems
CONTROLS
233
Online Edition for Part no. 01402720992 - II/19
Loading ...
Loading ...
Loading ...