Loading ...
Loading ...
Loading ...
60
• Sensitivity – Sensitivity is the amount of change required to increase the motion detected by a percentage. The
lower the sensitivity, the more movement is required to trigger an alarm.
• SMTP – Simple Main Transfer Protocol is an Internet standard for electronic mail (e-mail) transmission.
• Static IP – An IP address that does not change.
• Sub Stream – Sub Stream is an alternative streaming protocol for the camera. Sub stream uses less bandwidth and
attempts to keep fluency high at the expense of quality.
• Subnet Mask – a 32-bit number that masks an IP address, and divides the IP address into network address and host
address.
• TCP/IP – TCP/IP stands for Transmission Control Protocol/Internet Protocol and it is the language/protocol that
allows communication between internet connected devices, whether on a local network, or a on the Internet at
large.
• Threshold – Threshold is the level that the motion detection needs to reach to trigger an alarm.
• UPnP – UPnP stands for Universal Plug and Play, and it is a protocol used to easily connect devices to the internet.
• Video Tamper – Video Tamper refers to any major changes happening to the video feed such as it being blocked
out, interfered with, or disconnected.
FCC Statement
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
2. The user’s manual or instruction manual for an intentional or unintentional radiator shall caution the user
that changes, or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment. In cases where the manual is provided only in a form other than paper,
such as on a computer disk or over the Internet, the information required by this section may be included in the
manual in that alternative form, provided the user can reasonably be expected to have the capability to access
information in that form.
3. (b) For a Class B digital device or peripheral, the instructions furnished the user shall include the following
or similar statement, placed in a prominent location in the text of the manual: NOTE: This equipment has been
tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving
antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an
outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced
radio/TV technician for help.
4. RF exposure warning This equipment must be installed and operated in accordance with provided
instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at
least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or
transmitter.
End-users and installers must be provided with antenna installation instructions and transmitter operating
conditions for satisfying RF exposure compliance.
Loading ...
Loading ...