Loading ...
Loading ...
Loading ...
Calibration Reset
If desired, the calibration memory of your FiX™ 82 may be reset to an original
“factory” state. This may be useful during troubleshooting or when transferring
equipment from one vehicle to another. To reset the calibration memory of
your FiX™ 82: Press and hold the “Calibrate” button for 15 seconds until the
“Calibration Status” LEDs begin to alternate green, then release the button. The
“Calibration Status” LEDs will cycle through amber-red-green colors x 3 times,
then flash amber to confirm the reset status.
7
JLID Port and DRC-100 Function (optional)
The JLID port is designed to allow connection of the optional DRC-100 Digital
Remote Controller (sold separately). Connecting a DRC-100 to the FiX™ 82 will
add remote Master Volume Control, Handsfree Optimization and LED Status
Reporting features to the FiX™ 82. Since these are driver-controlled functions,
we recommend mounting the DRC-100 within easy reach of the driver, on the
center console or dashboard of the vehicle. (Refer to the installation instructions
included with the DRC-100 for detailed info.)
Master Volume Control: When used as a Master Volume Control, the DRC-100
maintains linear frequency response at all volume levels and delivers the best
signal-to-noise performance for your audio system. To use, leave the volume
control of your OEM source unit at the specific volume position that was
used during calibration. From now on, you will use the DRC-100 to control
your audio system volume, leaving the OEM volume control at the calibration
level. You may continue to use the OEM source unit’s tone, balance and fader
controls, if desired.
Handsfree Optimization: The FiX™ 82 includes a Handsfree Mode designed
to optimize the audio clarity of your vehicle’s handsfree telephony system, if
equipped. When Handsfree Mode is activated, the FiX™ 82’s time correction
function is disabled and a 100 Hz high-pass filter is applied to the audio
outputs. Press the DRC-100 control knob once to activate Handsfree Mode.
The DRC-100 status LED and the JLID LED on the FiX™ 82 will both illuminate
amber to signify that Handsfree Mode is activated. When the call is finished,
press the DRC-100 control knob again to deactivate Handsfree Mode,
returning the color of the LEDs back to green.
LED Status Reporting: The DRC-100’s multi-color LED will illuminate to report
the FiX™ 82’s overall condition to the driver. Refer to the table below for the
color and meaning of the LED’s behavior.
LED Color Status/Condition
Constant green Normal operation
Slow green ash Valet mode is active
Constant amber Handsfree mode is active
Flashing or constant red Clipped input signal detected*
*Reduce output level of the source unit
Loading ...
Loading ...
Loading ...