Loading ...
Loading ...
Loading ...
21
31-1000169 Rev. 4
INSTALLATION INSTRUCTIONS FOR MULTIPLE UNITS (cont.)
67(35(029(3$&.$*,1*$//81,76
WARNING
Tip Over Hazard.
This appliance is top heavy. Use extreme caution
with moving to prevent tipping over which could
result in death or serious injury.
Ŷ Cut bands and tape on the top and bottom of
packaging with a utility knife.
Ŷ Unfold the cardboard seams and remove the top of the
packaging.
Ŷ Slide the remainder of the box off of the appliance. You
can use a box cutter to cut the remaining cardboard
being VERY CAREFUL not to scratch the appliance.
Ŷ Remove the EPS supports from around the unit.
Ŷ DO NOT remove the door band or lower EPS banded
parts until unit is ready to go into enclosure.
Ŷ Remove anti-tip bracket and foam blanket from top of
unit and set aside for installation later.
Ŷ Keep front door band and door/drawer tape on unit
until product is installed to anti-tip bracket.
Ŷ Remove trim pieces taped to front of product and set
aside for installation later.
Ŷ Remove all packing tape except for warning labels and
tape with orange warning labels.
Ŷ Pull back, but DO NOT REMOVE, door/drawer tape.
Ŷ Open middle drawer and remove Owner’s Manual
packet which includes unit installation instructions.
Ŷ Close middle drawer and re-apply tape to keep the
door and drawers closed until product is installed to
anti-tip bracket.
Ŷ Cut EPS skid at the sides near the front from the back
of the unit.
Ŷ Push unit forward & remove rear portion of the EPS
skid.
Ŷ Carefully lower rear onto the floor.
Ŷ Lean unit back slightly & remove front portion of the
EPS skid.
Ŷ Discard all unused packaging materials appropriately.
Ŷ The unit can now be moved using an appliance hand
truck or rolled on a properly protected floor by 2
people.
Ŷ Leave any protective film on the unit until installation is
complete.
Installation Instructions
Loading ...
Loading ...
Loading ...