Loading ...
Loading ...
Loading ...
9
Conversion from liquid gas to natural gas
If the appliance is to be converted from liquid gas
(LPG: G30, G31) to natural gas (NG: G20, G25):
When natural gas (NG) is used, gas is connected via a gas line
or a safety hose using a connecting piece with a screw thread
at each end.
Connection as per EN ISO 228 G
^ (TS EN ISO 228 G^ )
1. The connecting hose on the appliance must be replaced with
a natural gas adapter. First remove the safety hose, if
present, by loosening the screw connection or the fastening
clip from the appliance. Figure 1.
Attach the connecting piece (with a size 24 key) to the end of
the gas connection (with a size 22 key). Figure 2.
2. Place the new seal on the connecting piece. Make sure that
the seal is correctly seated.
3. Attach the connecting piece (with a size 24 key) to the end of
the gas connection (with a size 22 key).
4. Attach the threaded connecting piece of the gas line or safety
hose (with a size 24 key) to the connecting piece with a new
seal, and tighten it.
5. To perform a leak test, see the section entitled "Leak test".
Open the gas supply.
Notes
■ *G^: EN ISO 228 G^ (TS EN ISO 228 G^)
■ A torque spanner should be used when converting the gas
type.
Connection as per EN 10226 R
^ (TS 61-210 EN 10226 R^ )
1. The connecting hose on the appliance must be replaced with
a natural gas adapter. First remove the safety hose, if
present, from the appliance by loosening the screw coupling
or the hose clamp. Figure 1.
Attach the connecting piece (with a size 24 key) to the end of
the gas connection (with a size 22 key). Figure 2.
2. Place the new seal on the connecting piece. Make sure that
the seal is correctly seated.
3. Attach the connecting piece (with a size 24 key) to the end of
the gas connection (with a size 22 key).
4. Attach the threaded connecting piece of the gas line or safety
hose (with a size 24 key) to the connecting piece and tighten
it.
5. To perform a leak test, see the section entitled "Leak test".
Open the gas supply.
Notes
■ *R^: EN 10226 R^ (TS 61-210 EN 10226 R^)
■ A torque spanner should be used when converting the gas
type.
76(1,62*A
(1,62*A
6:
6:
6:
6:
6:
*ê
1***
1P
5A
76(1
(15A
6:
6:
6:
6:
6:
5ê
1***
1P
Loading ...
Loading ...
Loading ...