Loading ...
Loading ...
Loading ...
21
E08
Failure of the controller
EEPROM.
The 24C02 from the control board is broken down or you
forgot to install 24C02, change the motor control board.
E09
Controller is in tilted position.
Treadmill is not placed on level
surface when it is powered on
Place treadmill on a level
surface, then start the
treadmill.
E10
Transient current protection
Check if the torsion of
controller is normal.
Adjust the torsion
regulator to normal value.
Check whether the motor is
short-circuited.
Change the motor.
Check whether treadmill’s
transmission part is stuck.
Eliminate the disturbance,
and make sure the
treadmill runs smoothly.
E11
External AC over-voltage
Check whether the external AC voltage is higher than
270VAC, or if it is unstable; if yes, stop using the product
and ask qualified electrician for help.
E13
Communicational failure
between the console and the
controller, and the meter cannot
receive the signal from the drive.
Check whether the wire
between the console and the
controller is broken down.
Change the wire.
Check whether the socket is
plugged in well.
Re-plug the socket and
make sure it is reliable.
E14
External AC under-voltage
Check whether external AC voltage is lower than 160VAC
or if it is unstable, if yes, stop using the product and ask the
qualified electrician for help.
NOTE: If you are unable to resolve an issue using the troubleshooting guide above, please
contact Customer Service at [email protected]
Version 1.2
Loading ...