Loading ...
Loading ...
Loading ...
No.
Troubles
Possible causes
Solutions
9
The ice cream is too
soft.
Wrong mixing ratio of the pulp
Make qualified pulp
again.
Improper setting of the hardness
Reset the hardness.
Unsteady voltage
Adjust the voltage.
Loose belt
Adjust the belt or
replace it.
The material discharge is too frequent.
After the actual
hardness is over 1,
make the ice cream
then.
10
Non-stop of the
machine
The hardness is set too big.
Adjust down the set
hardness.
Poor refrigeration
Check the refrigerating
system.
The discharge switch is damaged or the
connection line is short-circuit.
Connect the line again
or replace the material
discharge switch.
11
Leaky material
Leaky liquid outlet valve
Replace the liquid outlet
valve and lock it with
the fixing nuts.
Leaky discharge hole
Replace the piston seal.
Leaky liquid joining pipe
Replace the bellmouth
seal and lock it with the
fixing nuts.
Leaky inside the machine
Replace the cylinder’s
connection pipe.
12
“JJ” alarms
The current of the stirring motor is too
high.
Check the belt’s
tightness, the stirring
motor and capacitance.
13
“UH” alarms
Too high voltage
Check the power
voltage.
14
“UL” alarms
Too low voltage
Check the power
voltage.
15
“Cb” alarms
The material discharge switch closes in
succession over 3 minutes.
Restore the material
discharge switch or
replace it.
（10）
Loading ...