Loading ...
Loading ...
Loading ...
8
INSTALLING YOUR APPLIANCE
Door Adjustments - MLNP115
DOOR ALIGNMENT AND ADJUSTMENT
Align and adjust the door if it is not level or not sealing
properly. If the door is not sealed, the unit may not cool
properly, or excessive frost or condensation may form in
the interior.
Properly aligned, the door’s gasket should be rmly in
contact with the cabinet all the way around the door (no
gaps). Carefully examine the door’s gasket to ensure
that it is rmly in contact with the cabinet. Also make
sure the door gasket is not pinched on the hinge side of
the door.
Do not attempt to use the door to raise or pivot your unit.
This would put excessive stress on the hinge system.
Alignment and Adjustment Procedure
1. Open door and remove gasket near the hinges.
2. Using a T-25 Torx bit, loosen each pair of Torx head
screws both the upper and lower hinge plates.
3. Square and align door as necessary.
4. Tighten Torx head screws on hinge.
5. Reinstall gasket into the channel starting at the
corner.
REVERSING THE DOOR
1. Open door.
2. Using T-25 Torx bit loosen screw #1 and remove
screw #2 on top and bottom hinge. Slide and remove
the door from the unit.
One hinge includes a metal spacer. Spacer must be
used with that hinge when reversing the door.
3. Remove caps from screw heads on opposite side
(2 on top and 2 on bottom). Using #2 Phillips bit,
remove the 4 underlying screws. Reinstall the
screws and caps on the opposite side.
4. Partially install screw #1 in the outer most holes on
top and bottom. Rotate door 180
o
, align hinge over
screw #1 and slide/seat into position. Reinstall screw
#2 on top and bottom. Tighten both screws and
install hinge cover.
Align and adjust the door:
Align and adjust the door (see DOOR ALIGNMENT AND
ADJUSTMENT).
NOTE
!
CAUTION
T-25 Torx Screw
T-25 Torx Screw
Figure 14
2
1
Figure 15
NOTE
Loading ...
Loading ...
Loading ...