Loading ...
Loading ...
Loading ...
10
INSTALLING YOUR APPLIANCE
Panel Installation
MLNP115-IS01A ONLY
3/4" (20 mm) panel
14" (379 mm) width
30" (762 mm) height
1. Fully open door.
2. Starting at corner, pull gasket
away from door.
3. Continue to pull gasket free from
gasket channel.
4. Upon removal, lay gasket down on a at surface.
5. Align top of panel with top edge of door. Center panel
on door.
Due to differences in oor construction or surrounding
cabinetry, the panel may not sit ush with the top of the
door.
6. Secure integrated panel to door using
clamps. A robust tape may also be
used. U-Line recommends the use of
bar clamps to secure the panel to
the door. If using tape, be certain the
tape will not damage panel nish upon
removal.
7. Using a 7/64” (3 mm) drill bit, drill 6 pilot
holes into the wood panel 1/2” (12 mm)
deep using the holes in the door frame
as a guide.
It is important to ensure that all drilled holes are drilled to
the correct depth in order to avoid splits in the wood when
hardwood is installed.
8. Locate 6 of the #6x 1-1/2” (38 mm) screws provided
with your unit.
9. Using a Phillips screwdriver, place one screw into each
of the 6 pilot holes and screw down. Do not over-
tighten screws.
10. Ensure the screws sit ush against the bottom of the
channel.
11. Remove clamps from door.
If panel requires additional adjustment after removing
clamps, slightly loosen each screw and adjust panel as
necessary. Tighten screws upon completion.
12. Starting at the corners, re-install the gasket into the
gasket channel in the frame. Make sure the gasket is
fully seated.
Figure 18
Figure 19
NOTE
NOTE
Figure 20
NOTE
Loading ...
Loading ...
Loading ...