WH8060P3 User Manual

Loading ...

BEFORE YOU CALL FOR SERVICE

User warnings

Your washer is capable of self diagnosis and may sound a series of beeps and display

anotification or warning to inform you when there is aproblem. In most cases you will be

able to address the problem the washer is alerting you to. Check this chart before you call

for service.

PROBLEM DISPLAYED AS WHAT TO DO

Keylock

is activated

Press and hold

button for threeseconds.

Pump filter

is blocked

Clean the pump filter

The washer

is not getting

any water

Check the taps have been turned on

If there is no hot water connection the washer will heat the

water itself, but there must be a cold water connection to the

cold valve.

Check the hose connections. If the cold water supply is

connected to the hot valve and there is no connection to the

coldvalve the washer will not fill.

Check the inlet hose filters are not blocked, the hose(s) are not

kinked and are attached correctly.

Check that the drain hose is not too low or pushed into the

standpipe too far. This will cause the water to siphon out of

thewasher.

Check that the cold water temperature does not exceed the

35°Ctemperature requirement.

Check the water flow rate. It maybe too low.

The washer is

out of balance

The wash load has gone out of balance at some point during the

cycle. Touch

to stop message. If you want to improve the

dryness of the load, manually re-distribute the load and remove

items if necessary. Close the door and select the

SPIN cycle on

the dial, adjust the spin speed if necessary and touch

to start

the washer.

Check the washer is level.

Loading ...

User Manual - Page 50