Loading ...
Loading ...
Loading ...
INSTALLATION GUIDE
14
A test cycle must be carried out anytime the washer is moved or tipped, this will ensure the
washer has been correctly re-installed.
If there are any problems, you must address these before proceeding with normal use. The
washer will automatically turn off at the end of the cycle if there are no problems.
3
Press to start. The washer will start to fill.
4
Wait until you see water in the bottom
of the drum.
Press
to stop the cycle, then press
to turn the washer off.
Press
again, select the SPIN cycle and
press .
Check the drain hose is firmly secured to the
standpipe or tub, or spigot.
Observe that the washer pumps out the
water, and spins.
The washer will beep to signal the end of
the cycle. Any faults will be displayed on the
screen, refer to ‘Fault codes’.
5
6
Loading ...
Loading ...
Loading ...