Additional Tools (depending on application)
21/8"
54 mm
1"
25 mm
A
or
or
1 / 4
Latch
Exterior Assembly
Battery Cover
Strike
Latch and
Strike Screws
Tailpiece
Mounting Plate
Interior Assembly
Screws
Interior
Assembly
Mounting Plate Screws
For 13/4"
thick doors
For 13/8"
thick doors
Align tabs with
holes in collar.
Install latch
in door
with wood
block and
hammer.
Ensure collar
snaps into place.
Pull collar to
test for tight it.
Make sure
slotted hole
is at bottom
of latch.
If drilling a new door, use the supplied template and the complete door drilling
instructions available at www.kwikset.com/doorprep
backset
Measure to conirm that the hole in
the door is 21/8" (54 mm).
Measure to conirm that the backset is
either 23/8" or 23/4" (60 or 70 mm).
23/8" or 23/4"
60 or 70 mm
13/8" or 13/4"
35mm or 45 mm
Measure to conirm that the hole in
the door edge is 1" (25 mm).
Measure to conirm that the
door is either 13/8" or 13/4"
(35 mm or 45 mm) thick.
A B C D
Ruler4 AA Batteries
Hammer
Wood
block
Phillips screwdriver
Required tools
ENGLISH
67530
Rev 02
Installation and User Guide
Kwikset
Technical Support
1-800-327-5625
www.kwikset.com
Parts in the box
A B C
Is the door edge chiseled?
Hold the latch in front of the door hole, with the
latch face lush against the door edge.
Install strike on the door frame.
180°
not
chiseled
chiseled
Install latch in door
with supplied screws.
Use a lathead screwdriver to
lift tabs on collar of rectangular
face to remove it from latch.
Install drive-in collar.
Is the slotted hole centered in the door hole?
YES NO
slotted hole
is centered
slotted hole is
NOT centered
No adjustment is
required. Proceed
to next step.
Rotate latch
face as shown to
extend latch.
Make sure
slotted hole is at
bottom of latch.
Yes NO
905 Keyless Entry
Touchpad Deadbolt
A
B
D
G
H
J
K
L
M
E
F
C
A
door frame
Make sure hole in door frame is drilled a
minimum of 1” (25 mm) deep.
C
H (x2)
H (x2)
B
A
A
1
Prepare the door and check dimensions
2
Install the latch and strike
Loading ...
Loading ...
Loading ...
