Loading ...
Loading ...
Loading ...
SECTION 1 Set-Up & First Brew
PRIME
ME NU
BR EW
ME NU
READY
NOT
Setting Up Your Brewer
1. Unwrap cord and plug the Brewer into
a grounded outlet. Remove all pieces of
packing tape and clear plastic sticker
from LCD display.
2. Place a Large Mug (10 oz. minimum) on the
Drip Tray Plate.
3. Remove the Water Reservoir from Brewer
by first removing Lid from Reservoir (fig. 1),
then lifting Reservoir straight up and toward
front of Brewer (may be tight), (fig. 2). Rinse
with fresh water.
4. Fill Water Reservoir with bottled or filtered
water so that the water level is just below the
top edge of the Water Reservoir.
IMPORTANT: You cannot use your Keurig
®
Brewer until
it has been set up for its first use as set forth below.
NOTE: If Brewer has been exposed to temperatures
below freezing, allow Brewer at least two hours to
reach room temperature before brewing. A frozen
or extremely cold Brewer will not operate.
5. Place Water Reservoir base into
the left side of the Brewer and be
sure the Water Reservoir Lock Tab
engages with the Brewer. Replace
Lid on Water Reservoir.
6. Press and release the Power
Switch found directly behind the
Brewer. Switch is spring loaded
and will return to original position.
7. The Blue LCD Control Center will
come on and indicate “NOT READY”
and the BREW Button will flash.
NOTE: A K-Cup should not be used
for this Sequence
.
8. The Brewer will automatically fill the internal
tank with water and then the water will be
heated. This will take about 4 minutes.
During the heating period, “NOT READY”
(fig. 3) is displayed on the LCD Control Center.
Do not lift Brewer Handle during this
‘heating period’. Once the water is heated,
“READY TO BREW” will be displayed and the
BREW Button will flash (fig. 4).
NOTE: You may see small amounts of water
coming from the Vent and dripping into the
Water Reservoir during this and subsequent
heating — this is normal.
fig.
2
fig.
3
fig.
1
6
Lock Tab
Loading ...
Loading ...
Loading ...