Loading ...
Loading ...
Loading ...
©2018 Hestan Commercial Corporation
15
EN
PRESSURE TEST PROCEDURE
1) Remove grate and burner cap (A).
2) Remove gas spreader (B).
3) Temporarily remove the orifice (C).
Note - for the 36” unit’s stacked burner, you will use the center (simmer) orifice, and set the
knob to SIM so that the main orifice does not flow.
4) Connect the pressure test gauge into the port that you removed the orifice from. (M6 x 0.75)
5) For 30” unit”, turn the knob for the test burner to HI.
For 36” unit, turn the knob for the test burner to SIM.
6) Check if the cooktop has the correct pressure
7) Turn the control knob OFF.
8) Remove the gauge and re-install the orifice.
Put the gas spreader, burner cap, and grate back into position.
C
A
B
Figure 16.
Regulator pressure test port (KGC 30)
C
A
B
Figure 17.
Regulator pressure test port (KGC 36)
GAS CONNECTION
(continued)
Loading ...
Loading ...
Loading ...