User Manual Kwikset 99390-002 Halo Wi-Fi Smart Lock Keyless Entry Electronic Touchscreen Deadbolt Featuring SmartKey Security

• User Manual - (English)

Installation and User Guide WI-FI TOUCHSCREEN SMART LOCK for Kwikset 99390-002 

Contents

• Prepare the door and check dimensions
• Install the batteries and perform the door handing process
• Test the lock and check door alignment
• System Reset
• Important Safeguards

Prepare the door and check dimensions

1. Make sure your door is compatible. If you have a standard deadbolt mounted separately from the handle below it, your door is compatible.
2. Remove your existing deadbolt from your door.
3. Measure to confirm that the hole in the door is either 2-1/8" (54 mm) or 1-1/2" (38 mm).
4. Measure to confirm that the backset is either 2-3/8" or 2-3/4" (60 or 70 mm).
5. Measure to confirm that the hole in the door edge is 1" (25 mm).
6. Measure to confirm that the door is between 1-3/8" and 2" (35 mm and 51 mm) thick.

Install the batteries and perform the door handing process

This step will teach your lock the orientation of your door and is crucial to lock operation.

1. Install 4 AA batteries in the battery pack.
2. With the door open, install the battery pack to initiate auto-handing.
3. After a few seconds, the latch bolt will retract and extend on its own to learn the orientation of the door. This is called the door handing process, and it is crucial to lock operation.

Test the lock and check door alignment

1.  With the door open, insert the key to  extend the latch. Ensure that the latch
2. Turn the key 180° to retract the latch. Ensure that the latch extends smoothly. retracts smoothly.
3. Close the door. Insert and rotate the key to lock the door. Ensure that the door locks smoothly. unlocks smoothly.
4. Turn the key 180° to retract the latch. Ensure that the door

System Reset

System Reset will delete all access codes and lock settings including lock handing. The lock will run the handing process at the end of the System Reset.

1. Press "A" 10 times. You will hear 1 short beep and see a blinking amber LED to indicate it is in system reset mode.
2. Press and release the Program button to confirm system reset.
3. If successful, you will hear 1 long beep and see a green LED, and the reset process will begin. During the reset process, the LED will blink green/red a few times and
    will beep when complete. If unsuccessful, you will  hear 5 rapid beeps and see a blinking red LED. If unsuccessful, repeat from step 1.

Important Safeguards

1. Read all instructions in their entirety.
2. Familiarize yourself with all warning and caution statements.
3. Remind all family members of safety precautions.
4. Protect your user codes.
5. Dispose of used batteries according to local laws and regulations.