Loading ...
Loading ...
Loading ...
Installation
64
5.6 Electrical connection
General information
Check the grid characteristics against the
data indicated on the plate.
The identification plate bearing the
technical data, serial number and brand
name is visibly positioned on the appliance.
Do not remove this plate for any reason.
Perform the ground connection using a wire
that is 20 mm longer than the other wires.
The appliance can work in the following
modes:
• 220-240 V 1N~
Use a 3 x 0.75 mm² three-core cable.
Fixed connection
Fit the power line with an omnipolar circuit
breaker with contact separation equal to or
greater than 3 mm in compliance with
installation regulations.
The circuit breaker should be located near
the appliance and in an easily reachable
position.
Power voltage
Danger of electrocution
• Have the electrical connection
performed by authorised technical
personnel.
• Use personal protective equipment.
• The appliance must be connected to
earth in compliance with electrical
system safety standards.
• Disconnect the mains power supply.
• Do not pull the cable to remove the
plug.
• Use cables withstanding a temperature
of at least 90°C.
• The tightening torque of the screws of
the terminal supply wires must be 1.5 -
2 Nm.
Pass the power supply cable
through the back of the unit, taking
care that it does not touch the
bottom casing of the hob or the
oven (if any) installed underneath it.
The values indicated refer to the
cross-section of the internal
conductor.
Loading ...
Loading ...