Loading ...
Loading ...
Loading ...
28
SETTING OVEN CONTROLS
Operating the oven light
The oven light will automatically turn ON when the oven
door is opened.
Press to turn the oven light ON and OFF whenever
the oven door is closed.
The oven light is located at the upper left rear wall of the
oven interior and is covered with a glass shield held by a
wire holder. The glass shield must be in place whenever
the oven is in use.
Your appliance has been factory calibrated and tested
to ensure an accurate baking temperature. For the rst
few uses, follow your recipe times and temperature
recommendations carefully. If you think the oven is
cooking too hot or too cool for your recipe times, you can
adjust the control so the oven cooks hotter or cooler than
the temperature displayed.
The oven temperature may be increased +35°F (+19°C)
or decreased -35°F (-19°C) from the factory settings.
Example: increase the oven temperature by 30°F:
Adjusting the oven temperature
Step Press
1. Press and hold bake
for 6 seconds.
2. Enter 30.
3. To accept, press start.
Example: decrease the oven temperature by 30°F:
Step Press
1. Press and hold bake
for 6 seconds.
2. Enter 30.
3. Press self clean.
4. To accept, press start.
NOTES
Restoring to factory default settings
When new, your appliance was set with preset oven
control settings. Over time, the user may make changes to
these default settings.
The following features have user program options or
adjustments that may have been modied from the factory
default settings:
• 12 or 24 hour clock display mode.
• 6-Hour Engergy Savings or continuous bake mode.
• Silent or audible keypad operation.
• Oven temperature display mode (F° or C°).
• Any oven temperature offset adjustment made.
• Temp probe options (some models).
• Any stored favorite recipes (some models).
Before restoring the settings, be aware that all
changes made to the oven control settings will be
erased once the start keypad is pressed. This includes
any temperature offset made for the oven.
1. Press and hold 7 keypad until
acceptance tone sounds
(about 6 seconds).
2. To accept, press start.
Step Press
To restore oven control to factory settings:
• Oven temperature adjustments made will not affect
the broil or self-clean operating temperatures.
• If the temperature shows an adjustment of -30°F,
and a +30°F adjustment is needed, you can toggle
between the (-) or (+) in the display by pressing self
clean.
• Do not use oven thermometers such as those found
in grocery stores to check the temperature settings
inside your oven. These oven thermometers may
vary as much as 20 to 40 degrees from actual
temperatures.
NOTE
The oven light will not operate when self-clean is active.
If the oven light is ON when setting self-clean, the oven
light will turn off.
IMPORTANT
Loading ...
Loading ...
Loading ...